ISO 4665-2016是关于硫化或热塑性橡胶-耐候性测试方法。 本标准规定了以荧光紫外灯和冷凝装置模拟天然气候的太阳紫外光、温度和冷凝水等老化因素的一种人工气候老化试验方法。

本标准适用于硫化橡胶在紫外光照和冷凝作用交替条件下暴露的耐候性试验。最新标准ISO 4665-2016发布于2016年1月。

ISO 4665-2016英文介绍

ISO 4665:2016 specifies methods for the exposure of vulcanized or thermoplastic rubbers to natural or artificial weathering and methods for the determination of changes in colour, appearance, and physical properties resulting from exposure.

1 Scope

This International Standard specifies methods for the exposure of vulcanized or thermoplastic rubbers to natural or artificial weathering and methods for the determination of changes in colour, appearance, and physical properties resulting from exposure.

2 Normative references

The following documents, in whole or in part, are normatively referenced in this document and are indispensable for its application. For dated references, only the edition cited applies. For undated references, the latest edition of the referenced document (including any amendments) applies.

ISO 105-A02, Textiles — Tests for colour fastness — Part A02: Grey scale for assessing change in colour

ISO 877-1:2009, Plastics — Methods of exposure to solar radiation — Part 1: General guidance

ISO 877-2:2009, Plastics — Methods of exposure to solar radiation — Part 2: Direct weathering and exposure behind window glass

ISO 877-3:2009, Plastics — Methods of exposure to solar radiation — Part 3: Intensified weathering using concentrated solar radiation

ISO 1431-1, Rubber, vulcanized or thermoplastic — Resistance to ozone cracking — Part 1: Static and dynamic strain testing

ISO 4892-1, Plastics — Methods of exposure to laboratory light sources — Part 1: General guidance

ISO 4892-2, Plastics — Methods of exposure to laboratory light sources — Part 2: Xenon-arc lamps

ISO 4892-3, Plastics — Methods of exposure to laboratory light sources — Part 3: Fluorescent UV lamps

ISO 4892-4, Plastics — Methods of exposure to laboratory light sources — Part 4: Open-flame carbon-arc lamps

ISO 18314-1, Analytical colorimetry — Part 1: Practical colour measurement

ISO 23529, Rubber — General procedures for preparing and conditioning test pieces for physical test methods

3 Terms and definitions

For the purposes of this document, the terms and definitions given in ISO 877 and ISO 4892 and the following apply.

3.1control

material exposed alongside the test material for comparison

Note 1 to entry: The control, for example, may be a material of similar or related composition to the test material or a material having a known response to the exposure conditions.

3.2file test piece

portion of the material to be tested which is stored under conditions in which it is stable and is used for comparison between the exposed and the original state

3.3masked area

portion of the exposed test piece which is protected from light exposure by masking

3.4weathering reference material

reference material whose weathering degradation properties are well documented and repeatable when exposed to identical conditions

3.5exposure stage

interval of exposure between determinations of change in properties, expressed as time or radiant exposure